When processing curved tempered glass, we will use a standard template to adjust the shape of the lower bending chiller to meet the curvature of the standard template. Any deviation in the adjusting process may lead to a smaller radius of the bent glass. In this case, we should re-adjust the curvature using the template.
The failure of the furnace heating elements or thermocouple will affect the control of the furnace temperature, resulting in improper glass exit temperature, which leads to inaccuracy of bent glass curvature. In this case, please check whether the furnace heating elements and thermocouples are working properly.
To measure the local bow of the tempered glass, place the tempered glass on an inspection bench. Press a 300 mm knife edge ruler vertically against the glass surface (about 200mm away from the edge of the glass) in a direction perpendicular to the direction of the conveyor rollers of the glass tempering furnace during glass processing. Measure the lower surface of the glass while it is being processed. Use the feeler gauge to measure the gap between the glass surface and the knife edge ruler.
During the glass tempering process, what will cause white haze at the front and back ends of the glass sheet? white haze are likely to appear at two ends of a glass sheet larger than 1.5m2 with a shape close to a square.Causes……
Daily Inspection should include:Cleanliness of glass tempering furnace；Whether the pressure and flow rate of the cooling water line in the convection tempering furnace are within normal range；Whether the drive of each part of the tempering machine works properly
During glass tempering process, if the curvature needs to be adjusted, the following steps are required:
Firstly, make a bending mold for the glass according to the curvature of the bent tempered glass to be processed……
Fabricating debris on the roller conveyor of the glass tempering furnace will cause regular scratches in the glass surface. As the location of fabricating debris is fixed, the scratches on the glass will show a regular pattern. We can check the state of the rollers in the heating oven and cooling section and tackle the issue accordingly.
If the glass is unevenly heated in the glass tempering furnace, the glass warps and form a spherical surface. It may result in its edges and corners being chipped when colliding with the ceramic roller conveyor during oscillating movement.
Differences in the wind pressure at different positions of the chiller will cause the tempered glass in the corresponding areas to have different flatness . Take the following measures to tackle the issue
