When there are discrepancies in the curvature settings of the bending chillers in the glass tempering furnace, or when the glass deviates during motion, it can cause the bent tempered glass to have inaccurate curvature and its diagonal corners to not lie on the same plane.
White haze can appear in the center of tempered glass during the glass tempering process for several reasons:If the tempered glass oscillates too quickly inside the glass tempering furnace, white haze may occur……
The main operating station of the glass tempering furnace and the control boxes for the critical components are each equipped with emergency stop buttons. Should an emergency arise, the operator can instantly halt all driving operations of the glass tempering furnace by pressing these buttons.
In the field of glass tempering process, the air compressor supplying compressed air to the glass tempering furnace is very important. Not only does it provide the necessary power to various components of the glass toughening machine, but it also significantly contributes to maintaining a balance in the furnace temperature.
How to measure the local bow and the edge kink of tempered glass? Measure the gap between the glass and the ruler with a feeler gauge. The maximum value is the local bow of the glass.
When tempering glass with holes and slots, the heating time should be increased by 2.5% to 5% compared to glass of the same size without holes and slots
The lifting mechanism of the heating furnace in glass tempering furnace is mainly composed of a gear motor, driving shaft, gears, lead screw nut mechanism, and guide pillars.
In order to eliminate the adverse effects of nickel sulfide in tempered glass, a heat soaking furnace should be used to homogenize the tempered glass after the tempering is completed in the glass tempering furnace.
Shut off the glass tempering furnace and allow it to naturally cool down to the ambient temperature. Raise the upper part of the furnace body and insert safety pins in the columns at the corners of the furnace body. With personnel safety ensured, turn the ceramic roller by the handle and clean the ceramic rollers…
