Energy consumption of the amount of energy required to process certain quantity of glass. Installed power of a glass tempering machine takes no effect on its energy consumption but does determine its processing efficiency.
What is the cost structure of a glass tempering furnace?1. Material cost.2. Labor costs for glass tempering furnace operation.3.Other costs such as R&D, maintenance, and upgrading are also components in the total cost structure of a glass tempering furnace.
When the glass enters the glass tempering furnace, due to the physical contact with the rollers, the lower surface of the sheet will expand faster than the upper surface and cause the glass sheet bending up all around, leaving only the center part remaining in contact with the rollers.
When glass heating temperature exceeds the softening point, the glass can be easily deformed, and significant damage will be caused to the surface quality of tempered glass.
Glass with poor edging tends to blast during the process of heating or cooling due to excessive concentration or uneven distribution of stress caused by edge defects. This may lead to significant damage to the glass tempering furnace.
During tempering process, in cases where the furnace doors are not opened in time, heating time is too long, the conveyor is stopped or encountering other mechanical malfunctions, the glass may get stuck to the ceramic rollers of the glass tempeirng furnace. The proper way to handle the situation is as follows:
What type of glass tempering furnace is the best choice for tempering ultra thin PV glass?Continuous Tempered Glass Machine of LandGlass will be your best choice for tempering ultra thin PV glass.
By adopting LandGlass’ Adaptive Compensating System, the impact on the quality of tempered glass due to ambient temperature fluctuation can be eliminated effectively.
To ensure the smooth lifting of the furnace, the trapezoidal lead screw rods inside the pillars need be lubricated with N46 oil after every lift (or at least once a month). Apply lithium grease to the bevel transmission gears once every quarter.
